OFDM Physical Layer

We have chosen OFDM as the underlying physical layer for our research. Currently a SISO OFDM transceiver is fully implemented and tested in hardware. This model is available via the repository.

OFDM Models Overview

Our SISO OFDM transceiver is implemented as two Simulink models built using Xilinx's System Generator for DSP. Both models are designed from scratch for real-time, wideband operation on the WARP hardware. The models have top-level interfaces to the WARP radio board's Tx/Rx analog converters. They also utilize an OPB interface for data exchange and control by the embedded PowerPC in the WARP FPGA.

Performance

Some basic performance paramters are listed below. This page will be updated as we further verify and extend the models in hardware.

Bandwidth:

The effective bandwidth is currently 10 MHz. The ADC/DAC sampling rate is actually 50 MHz; interpolation/decimation filters are included in the models to achieve this rate change.

Moduation:

Both models support flexible modulation schemes, allowing individual subcarriers to carry [0, 1, 2, 4, 6, 8] bits. In other words, any combination of 0, BPSK, QPSK, 16/64/256 QAM can be used per packet. We have fully tested a QPSK-only system in hardware, loading 48 of 64 subcarriers with user data.

Data rate:

We have tested a 12 Mbps PHY configuration over-the-air (10 MHz bandwidth with 48 data-bearing subcarriers using QPSK modulation). We have also tested a 16 QAM system in hardware (running at 24 Mbps) and are in the process of fully verifying its operation now.