Changes between Version 11 and Version 12 of WARPLab/Examples/8x2Array

Timestamp:

May 14, 2013, 9:02:50 AM (11 years ago)

Author:

chunter

Comment:

--

WARPLab/Examples/8x2Array

@@ -21 +21 @@
 [[Image(8x2_overview.jpg,width=800)]]
 
-To run this example, you must setup your experiment as follows:
+To run this example, you must set up your experiment as follows:
  1. Mount the CM-MMCX modules on two WARP v3 nodes. Power must be '''off''' when mounting/unmounting a clock module.
  1. Mount the FMC-RF-2X245 modules on the same two WARP v3 nodes. For assistance installing an FMC-RF-2X245, see the [wiki:GettingStarted/WARPv3/Hardware#InstallinganFMCModule FMC Installation How-To].
@@ -27 +27 @@
  1. Connect MMCX cables from the outputs of the source node to the inputs of the sink node.
  1. Connect the twisted pair cable between the debug headers of the WARP v3 boards. Pin 8 of the source node should connect to pin 15 of the sink node. Use the other conductor of the cable to connect ground between nodes (see figure below).
- 1. Set the DIP switches on the WARP v3 boards to 0000 (source node) and 0001 (sink node).
+ 1. Set the DIP switches on the WARP v3 boards to 0000 (clock source node) and 0001 (clock sink node).
  1. Power on the two WARP v3 nodes
- 1. Download the WARPLab reference bitstream to both nodes (source node first). Both nodes should boot, with the source node showing "01" on the hex displays and the sink showing "02".
- 1. Power 
+ 1. Download the 4RF WARPLab reference bitstream to both nodes (clock source node first). Both nodes should boot, with the source node showing "01" on the hex displays and the sink showing "02".
+ 1. Set the DIP switch on the third WARP v3 board to 0010.
+ 1. Power on the third WARP v3 board and download the 2RF WARPLab reference bitstream. The node should boot and show "03" on the hex displays.