Changes between Version 8 and Version 9 of WARPLab6/ResearchApp/Cooperative

Timestamp:

Jul 10, 2010, 6:33:03 PM (14 years ago)

Author:

kiarash

Comment:

--

WARPLab6/ResearchApp/Cooperative

@@ -28 +28 @@
 
 
-Node topology in the Azimuth Director software. Port B corresponds to the source transmitter in the first time slot. Also, A1 and A4 correspond to the relay two receive antennas in the first time slot, and A2 and A3 correspond to the destination receive antenna in the first time slot. In the second time slot, A2 and A3 are the relay transmit antennas and port B serves as the destination receiver:
+The parameters of the Azimuth channel emulator can be controlled through Azimuth Director software. The figure below shows one screenshot of the node topology in this software used for the cooperative partial detection setup. Port B corresponds to the source transmitter in the first time slot. Also, A1 and A4 correspond to the relay two receive antennas in the first time slot, and A2 and A3 correspond to the destination receive antenna in the first time slot. In the second time slot, A2 and A3 are the relay transmit antennas and port B serves as the destination receiver:
 
 [[Image(WARPLab/Images:emulator_topology.pdf, 450px)]]
@@ -41 +41 @@
 [[Image(WARPLab/Images:emulator_power_setting.pdf, 450px)]]
 
+== MATLAB Files and FPGA Bitstreams ==
+The MATLAB reference files for this setup is available here. 
+The FPGA bitsreams, which are based on the "2x2 MIMO bitstream for FPGA Version 1" is available here.
 
+In order to ensure that the reference design properly works, make sure that:
+1.