3 | | Coming Soon! |
| 3 | == Hardware Requirements == |
| 4 | |
| 5 | * Power Supply for the WARP FPGA Board (12V-DC) |
| 6 | * Parallel Cable w/ JTAG (Requires 5V-DC supply for Xilinx Parallel Cable IV) |
| 7 | * 9-pin serial cable |
| 8 | |
| 9 | == Connecting the Board == |
| 10 | 1. '''Connect and Power the Parallel Cable''' |
| 11 | * Attach the parallel cable to the 25-pin port on your computer. |
| 12 | * Attach the parallel cable to the board using the JTAG connector. (The connection to the board is underneath the board on the middle-left side) |
| 13 | * Connect the parallel cable to a 5V-DC power supply. (The status light on the parallel cable should be yellow before the board is powered) |
| 14 | 2. '''Connect the Serial Cable''' |
| 15 | * Attach the 9-pin serial cable to one of the COM ports of your computer |
| 16 | * Attach the serial cable to the board. (The connection to the board is in the lower right hand corner on the right side of the board) |
| 17 | 3. '''Connect and Power the WARP FPGA Board''' |
| 18 | * Connect a 12V-DC power supply to the FPGA board. (The connection to the board is in the bottom right corner on the bottom side) |
| 19 | * Turn the power switch on. The switch located to the left of the power connection. (Turning on the board should cause a number of LEDs to light. If there is no flash card in the flash port, then that LED will be blinking until one is inserted) |
| 20 | |