Changes between Version 3 and Version 4 of peripheral_test/hw_setup
- Timestamp:
- May 24, 2006, 8:36:33 PM (18 years ago)
Legend:
- Unmodified
- Added
- Removed
- Modified
-
peripheral_test/hw_setup
v3 v4 17 17 3. '''Connect and Power the WARP FPGA Board''' 18 18 * Connect a 12V-DC power supply to the FPGA board. (The connection to the board is in the bottom right corner on the bottom side) 19 * Turn the power switch on. The switch located to the left of the power connection. (Turning on the board should cause a number of LEDs to light. If there is no flash card in the flash port, then th at LED will be blinking until one is inserted)19 * Turn the power switch on. The switch located to the left of the power connection. (Turning on the board should cause a number of LEDs to light. If there is no flash card in the flash port, then the LED near the flash port will blink until one is inserted. This is not needed now.) 20 20