Changes between Version 17 and Version 18 of peripheral_test/sw_setup

Timestamp:

May 24, 2006, 9:54:14 PM (18 years ago)

Author:

bratton

Comment:

--

peripheral_test/sw_setup

@@ -43 +43 @@
  4. Right-click on '''Default: ppc405_0_bootloop''' in the right hand menu.  Uncheck '''Mark to Intialize BRAMs'''. 
  5. Right-click on '''Project: Peripheral Test''' and check '''Mark to Initialize BRAMs'''.  This step tells XPS to update the bitstream with your project.
- 6. Right-click on '''Project: Peripheral Test''' and select '''Generate Linker Script'''.  Make sure that each article under the '''Memory''' drop down menus is either set to '''iocm_cntlr''' or '''docm_cntlr'''
- 6. Choose '''Update Bitstream''' by either accessing it through '''Device Configuration''' on the top menu, or by clicking on the toolbar button (it says "Bram Init" on it).  This process will take 10-15 minutes depending on your computing speed. Longer may indicate an improper setup (esp. steps 4,5,6 of this section).
- 7. The file is now ready to download to the board.
+ 6. Right-click on '''Project: Peripheral Test''' and select '''Generate Linker Script'''.  Make sure that each article under the '''Memory''' drop down menus is either set to '''iocm_cntlr''' or '''docm_cntlr'''.  Click '''Generate'''
+ 7. Choose '''Update Bitstream''' by either accessing it through '''Device Configuration''' on the top menu, or by clicking on the toolbar button (it says "Bram Init" on it).  This process will take 10-15 minutes depending on your computing speed. Longer may indicate an improper setup (esp. steps 4,5,6 of this section).
+ 8. The file is now ready to download to the board.
 
 For help, please refer to the '''[wiki:peripheral_test/helpfaq Help/FAQ]''' page.