| 8 | 5. At the '''Select Board''' window, make the following selections and click '''Next''': |
| 9 | * Board vendor: ''Rice University CMC - WARP Project'' |
| 10 | * Board name: ''WARP FPGA Board 1.1'' |
| 11 | * Board revision: ''1.0a'' |
| 12 | 6. Make sure '''PowerPC''' is your selected processor. Click '''Next''' |
| 13 | 7. The '''Configure PowerPC''' window should appear, make the following designations and click '''Next''': |
| 14 | * Processor clock frequency: ''100.00 MHz'' |
| 15 | * Bus clock frequency: ''50.00 MHz'' (Bus speed should always be half of processor speed) |
| 16 | * Processor configuration: ''FPGA JTAG'' |
| 17 | * On-chip memory (OCM) |
| 18 | * Data: ''64 KB'' |
| 19 | * Instruction: ''128 KB'' |
| 20 | * Cache setup should be ''unchecked'' |
| 21 | 8. The next windows are '''Configure IO Interfaces'''. Depending on the size of your window, a varying number of IO devices will be available on each screen. Make sure the following are checked: |
| 22 | * LED_7SEGMENT |
| 23 | * LED_7SEGMENT_1 |
| 24 | * LEDs_4Bit |
| 25 | * Push_Buttons_4bit |
| 26 | * Check '''Use interrupt''' for the Push_buttons_4bit IO device. IMPORTANT: If you fail to do so now, consult the [wiki:peripheral_test/helpfaq Help Documentation] to learn how to add them once the project is created. |