You are not logged in.
Dear Sir
I am using WARPLab reference design 7.7.1 on the WARP v3 board. I am performing some energy detection (Spectrum Sensing in Cognitive Radio Networks) experiments for wireless signals. We have a Keysight handheld Spectrum Analyzer. Please suggest how can i make connections from single WARP board to the spectrum analyzer.
Thanks and Regards
Shruti
Offline
Please suggest how can i make connections from single WARP board to the spectrum analyzer.
You can connect the WARP v3 RF interface (SMA jack) directly to the spectrum analyzer input with a suitable RF cable (perhaps with a series attenuator if the analyzer's max input power is low). You will then need to configure the spectrum analyzer for whatever measurements you want to perform on the waveform you generate from WARPLab.
Offline